Operation; A) Fitting The Spare Tyre; B) Inserting The Batteries Into The Transmitter; C) Folding Up The Body - Reely Core Bedienungsanleitung

10. Operation

a) Fitting the spare tyre

The supplied spare tyre can be screwed onto the back of
the vehicle (see the arrow in the figure to the right).
A screw and screwdriver are provided. Do not apply force
when tightening the screw.

b) Inserting the batteries into the transmitter

Open the battery compartment on the transmitter (slide the battery compartment lid open) and insert two new bat-
teries. Ensure the correct polarity (positive/+ and negative/-), see the label in the battery compartment and on the
batteries. Replace the battery compartment cover.
When using rechargeable batteries, the operating time will be reduced considerably due to the lower volt-
age (rated voltage: disposable battery = 1.5 V, rechargeable battery = 1.2 V). We recommend using only
high-quality alkaline batteries instead of rechargeable batteries.
If you still wish to use rechargeable batteries, ensure that they are fully charged.

c) Folding up the body

If there is a protective film on the body, it must be removed.
The body is attached at the rear of the vehicle with 2 clips,
see the arrows in the figure to the right.
Pull the clips out and carefully fold the body forwards.
In the figure to the right, the spare tyre (Fitting the spare
tyre, see chapter 10. a) has not yet been fitted.
40