Yamaha PSR-7000 Bedienungsanleitung Seite 160

The DSP Effects & Parameters • DSP-Effekte und -Parameter • Effets et paramètres DSP
51. Unison. 52. 5th Harmo
Both of these effects produce a pitch-changed note in addition to the note played. With the default settings "Unison"
produces a note one octave above the original note while "5th Harmony" produces a note one fifth above the original
note.
1. PITCH
Sets the pitch of the added note in semitone steps.
2. INITIAL DELAY
Sets the delay between the initial note and the pitch changed note. "0" results in no delay. The higher the value the
greater the delay.
3. FINE1
4. FINE2
These parameters fine tune the pitch of the pitch-changed note. Two FINE parameters are provided to allow "detuning"
effects.
5. FEEDBACK GAIN
Sets the amount of feedback applied. Feedback allows a series of pitch-changed notes to be produced — the higher the
feedback value the greater the number of notes produced.
53. TouchWah 54. Wah+Dist
These are wah effects in which the depth of the wah is controlled by keyboard touch response.
1. SENSITIVITY
Sets the sensitivity of the effect to keyboard touch. The higher the value the greater the sensitivity.
2. CUTOFF FREQUENCY
Sets the cutoff frequency of the wah effect. The higher the value the higher the cutoff frequency.
3. RESONANCE
Sets the level of a resonant peak at the cutoff frequency. Higher values produce greater emphasis at the cutoff frequency.
55. Compressor 56. NoiseGat
The compressor can be used to smooth out level variations when playing voices such as guitar for a "tighter" sound.
The noise gate effectively minimizes hum and noise.
A compressor and noise gate effect with similar parameters.
1. ATTACK
Sets the attack time of the compressor/noise gate. Higher values produce a longer attack time.
2. RELEASE
Sets the release time of the compressor/noise gate. Higher values produce a longer release time.
3. THRESHOLD
Sets the threshold level at which the compressor/noise gate begins to take effect.
4. RATIO (Compressor only)
Sets the compression ratio of the compressor. Higher values produce greater compression..
5. OUTPUT LEVEL
Sets the output level of the effect sound. Higher values produce higher level.
158
Range: -12 ... +12
Range: 0 ... 127
Range: -50 ... +50
RANGE: -63 ... +63
Range: 0 ... 127
Range: 0 ... 127
Range: 1 ... 12
Range: 1 ms ... 40 ms
Range: 10 ms ... 680 ms
Range: -48 dB ... -6 dB
Range: 10 ... 20
Range: 0 ... 127