Yamaha PSR-7000 Bedienungsanleitung Seite 158

The DSP Effects & Parameters • DSP-Effekte und -Parameter • Effets et paramètres DSP
40. Echo
Although similar to the DelayL,R effect, Echo features independent feedback level parameters for the left and right
channels, plus a "high damp" parameter that simulates the high-frequency damping characteristics of most natural
acoustic environments.
1. L CH DELAY
3. R CH DELAY
Set the delay time between the direct sound and the first repeat. Independent parameters are provided for the left ("L
CH") and right ("R CH") channels.
2. L CH FB LEVEL
4. R CH FB LEVEL
Determine the amount of effect-sound feedback returned to the input of the corresponding delay stage channel: L CH FB
LEVEL for the left channel and R CH FB LEVEL for the right channel. Higher values produce a greater number of repeats.
5. HIGH DAMP
Produces a natural decay in the high-frequency components of subsequent repeats. The lower the value the faster and
more pronounced the drop-off in high-frequencies.
41. CrossDly
This is a "cross delay" effect in which the repeats from a sound in one channel are produced in the opposite channel.
1. LmR DELAY
2. RmL DELAY
The LmR DELAY and RmL DELAY parameters independently set the delay times for repeats crossing from left to right,
and from right to left, respectively.
3. FEEDBACK LEVEL
Determines the amount of effect-sound feedback returned to the input of the delay stage. Higher values produce a greater
number of repeats.
4. INPUT SELECT
Selects the first channel to be delayed ("L", "R"), or both channels simultaneously ("L&R").
5. HIGH DAMP
Produces a natural decay in the high-frequency components of subsequent repeats. The lower the value the faster and
more pronounced the drop-off in high-frequencies.
42. DistHARD 43. DistSOFT
Two distortion effects that can drastically alter you sound.
1. DRIVE
Sets the intensity of the distortion effect. Higher values produce more distortion.
2. AMP TYPE
Simulates a variety of amplifier types via which the distortion sound might be reproduced.
OFF Flat amp — the sound of a "direct feed" to a recording or sound reinforcement console.
STACK The powerful, expansive sound of "stackable" speaker cabinets.
COMBO A single 12" speaker unit in a compact enclosure.
TUBE Simulates the warm, relatively "soft" distortion produced by vacuum tube amplifiers.
3. LPF CUTOFF
The cutoff frequency of the low-pass filter applied to the distortion sound. No filter is applied when set to "Thru".
4. OUTPUT LEVEL
Sets the output level of the distortion sound. Higher values produce higher level.
156
Range: 0.1 ... 715 ms
Range: –63 ... 0 ... +63
Range: 0.1 ... 1
Range: 0.1 ... 355 ms
Range: –63 ... 0 ... +63
Range: L, R, L&R
Range: 0.1 ... 1
Range: 0 ... 127
Range: OFF, STACK, COMBO, TUBE
RANGE: 1.0kHz ... 18kHz, Thru
Range: 0 ... 127