Yamaha PSR-7000 Bedienungsanleitung Seite 157

The DSP Effects & Parameters • DSP-Effekte und -Parameter • Effets et paramètres DSP
2. AM DEPTH Range: 0 ... 127
Sets the depth of amplitude modulation. Higher values produce deeper modulation and therefore a more pronounced
tremolo effect.
3. PM DEPTH Range: 0 ... 127
Sets the depth of pitch modulation. Higher values produce deeper modulation and therefore a more pronounced vibrato
effect.
36. Auto Pan
This is a sophisticated pan program that allows creation of "rotary" pan in addition to straightforward pan effects.
1. LFO DEPTH Range: 0 ... 127
Sets the overall depth of modulation. Higher values produce deeper modulation and therefore a more pronounced pan
sweep.
2. L/R DEPTH Range: 0 ... 127
Sets the "depth" of the pan sweep from left to right and right to left.
3. F/R DEPTH Range: 0 ... 127
This parameter sets the apparent depth of the sweep from front to rear.
4. PAN DIRECTION Range: L<>R, L>R, L<R, Lturn, Rturn, L/R
Determines the direction in which the sound sweeps across the stereo sound field.
37. Auto Wah
A fully automatic wah effect that can be set to produce a wide range of sounds.
1. LFO FREQUENCY Range: 0 ... 127
Sets the speed of LFO (Low Frequency Oscillator) modulation, and therefore the rate of effect variation.
2. LFO DEPTH Range: 0 ... 127
Sets the depth of modulation. Higher values produce deeper modulation and therefore a more pronounced effect.
3. CUTOFF FREQUENCY
Sets the basic frequency around which the wah filter sweep will occur.
4. RESONANCE Range: 1 ... 12
Creates a resonant peak at the frequency determined by the CUTOFF FREQUENCY parameter, above. The higher the
value the higher the peak, and the more the sound at that frequency is emphasized.
38. DelayLCR 39. DelayL,R
In the DelayLCR effect, independent delays are provided for the left and right channels, plus a center delay. The
DelayL,R variation provides independently programmable delays for the left and right channels.
1. L CH DELAY
2. R CH DELAY
3. C CH DELAY Range: 0.1 ... 715 ms
Set the delay time between the direct sound and the first repeat. Independent parameters are provided for the left ("L
CH"), center ("C CH"), and right ("R CH") channels. Only the L CH DELAY and R CH DELAY time parameters are avail-
able for the DelayL,R effect.
4. FEEDBACK DELAY (DelayLCR)
3. FEEDBACK DELAY 1 & 4.FEEDBACK DELAY2 (DelayL,R)
Sets the delay time between repeats. The higher the value the longer the delay. In the DelayL,R effect independent feed-
back delay parameters are provided for the left and right channels.
5. FEEDBACK LEVEL Range: –63 ... 0 ... +63
Determines the amount of effect-sound feedback returned to the input of the delay stage. Higher values produce a greater
number of repeats.
Range: 0 ... 127
Range: 0.1 ... 715 ms
155