Troubleshooting - Philips SCD465 Bedienungsanleitung

Troubleshooting

EN
Problem
No sound on parent unit. Volume off or too low.
No connection
between units.
Battery pack does
not charge.
Interference or poor
reception.
LINK light (B-5)
flashing red / LINK
alarm (B-11) beeps.
12
Possible cause
Units out of range.
Units are set to different
channels.
Parent unit out of range of
tansmitted signal.
Battery life at an end.
Mobile or cordless phone(s)
too close to baby monitor.
Interference from other
baby monitors in the
neighborhood.
Battery power running low.
Transmitted signal is out of
range; e.g. there are too many
walls and/or ceilings between
baby unit and parent unit.
Parent unit located too close
to a window and picking up
interfering signals from other
appliances.
Units are out of range.
Interference from another
baby monitor.
Interference from another
FM source.
Solution
Turn VOLUME control (B-9) on
parent unit downwards.
Move parent unit closer to baby
unit.
Set channel selection switches
(A-7, B-10) to the same position
on both units.
Move parent unit closer
to baby unit.
Replace battery pack (B-13) of
parent unit.
Move phone(s) away from
baby monitor.
Switch both units to another
channel using the channel
selection switch (A-7, B-10).
Recharge battery pack in time.
Move parent unit closer
to baby unit.
Move parent unit away
from window.
Move units closer together.
Switch to a different channel
(A-7, B-10).
Remove other FM source.