Baby Unit; Parent Unit; Getting Your Baby Monitor Ready - Philips SCD465 Bedienungsanleitung

Baby unit

The baby unit can be mains or battery operated.When batteries
are installed, you have an automatic back up in case of mains
failure.
Mains operated use
1 Connect the power adapter cord to the power supply jack
(DC 9V — — < < + + - A-3) of the baby unit.
2 Connect the AC power adapter (A-9) to a wall outlet.
The baby unit is now ready for mains operated use.
Battery operated use
1 Remove the battery compartment cover (A-8) of the baby
unit, using a coin.
2 Insert four 1,5V AA batteries, noting the + and – configuration
inside the battery compartment (batteries are not supplied, we
recommend Philips Alkaline batteries).
3 Close the battery compartment cover (A-8), using a coin.
The baby unit is now ready for battery operated use.

Parent unit

A rechargeable battery pack has already been installed in the
parent unit.
1 Connect the power adapter cord (B-2) to the power supply
jack (DC 9V — — < < + + - B-14) of the charging base (B-3).
2 Connect the AC power adapter (B-1) to a wall outlet.
3 Place the parent unit in the charging base (B-3).
> The charging light (B-4) lights up red.
4 Leave the parent unit in the charging base (B-3) until the
batteries are fully charged (at least 14 hours).
> When the batteries are fully charged, the charging light (B-4)
will gradually dim.The parent unit can now be taken out of
the charging base and used cordlessly for up to 10 hours.

Getting your baby monitor ready

EN
7