Trouble Shooting - Scheppach biostar 3000 Originalbetriebsanleitung

Problem
The motor doesn't start.
The motor doesn't do anything, the
safety default switches on.
The motor is overloaded the safety
default switches on.
The shredder intake is diminished,
reduced cutting capacity.
Excessive vibrations/noise
24 English

Trouble shooting

Possible cause
a) The upper housing unit is not
properly closed.
b) The extension cable is defective.
c) No current is coming out of the
outlet.
d) The switch is defective.
e) The motor is defective, the
capacitor is defective
f) Shredder material is obstructing
the blade disc.
a) The extension cable has an
insufficient cross section
b) The cable between the power
system connection and the
shredder is too long.
a) The quantity of wet shredded
material is too high.
b) The blade and output areas are
clogged.
c) The blade is dull.
d) The cable between the power
system connection and the
shredder is too long.
The blade is either dull or worn out.
a) Blade nut/bolt loose
b) Cutting blade damaged
c) Machine damaged internally
Solutions
a) Screw in the safety thoroughly
b) Exchange the extension cable or
repair it.
c) Check the mains fuse.
d) See Fig. D
e) See Fig. D
f) Pull the main plug, open the
housing and clean it out.
a) Choose an extension cable with
a larger cross section
b) Create the shortest possible
way between the power system
connection and the shredder.
a) Select a smaller quantity of
shredded material. Now and
then, include dry shredding
material
b) Pull the main fuse, open the
housing and clean it out.
c) Resharpen or change
d) Choose an extension cable with
a larger cross section.
Turn blade, sharpen blade or
replace entirely.
a) Tighten blade nut/bolt
b) Replace blade
c) Contact Service Agent