When cleaning a room, make sure all
doors are closed.
When cleaning a whole level, make
sure that the cleaning robot will not be
able to travel behind doors.
If you want to move the cleaning robot
to another place, it is recommended to
turn off the robot when it is placed in the
station for charging (after the evacua-
tion of the dirt receptacle).
In order to become more familiar with the
RoboCleaner, we recommend reading the
Chapter "Frequently asked questions and
answers" at the end of these instructions.
Illustration
Switch on the station.
The indicator lamp - continuous clean-
ing lights up.
Illustration
Put the cleaning robot on the floor in
front of the station.
Illustration
Switch on the cleaning robot.
Note: The cleaning robot will first travel
to the station to empty the dirt recepta-
cle and to check the charging state of
the batteries. If required, the batteries
are charged. Then, the cleaning robot
starts its cleaning run.
Indicator lamps on the cleaning robot
Green Permanent
light
Blinks slowly Cleaning robot is
Fast flashing Batteries are
Red
See Chapter "Troubleshooting"
24
Start up
Cleaning run
searching for the sta-
tion
charged
Operation after a long rest period or af-
ter a depleted battery
If the cleaning robot is turned on with com-
pletely empty batteries, the appliance is not
operative. Perform the following steps to
put the appliance into operation:
Illustration
Place the cleaning robot near the sta-
tion, and press the battery contacts of
the robot against the battery contacts of
the station for approximately
60 seconds. This will evacuate the dirt
receptacle.
Place the cleaning robot at a distance of
50 cm in front of the station, and turn it
on.
Note: The cleaning robot autonomously
goes to the station and is charged. The
charge will take about 60 minutes.
Selecting the cleaning duration
Select the cleaning duration on the station
using the following table. (Basic setting:
continuous operation).
Illustration
Press the "Select cleaning duration"
button until the desired cleaning dura-
tion is set.
Note: The indicator lamps indicate the
selected cleaning duration.
Selecting the cleaning duration
Press once
Press twice
Press three
times
Press four
times
The cleaning process will start. If the select-
ed cleaning duration has elapsed, the clean-
– 10
EN
Cleaning duration 3 hours
for rooms smaller than
45 m
2
Cleaning duration 6 hours
for rooms between 45 and
90 m
2
Cleaning duration 9 hours
for rooms between 80 and
135 m
2
back to continuous opera-
tion (basic setting)