Kärcher RC 3000 Originalbetriebsanleitung Seite 29

Problem
Cleaning robot runs une-
venly on carpets, bobs up
and down
Cleaning robot only runs in
star-shaped pattern
Cleaning robot cannot find
the station
Cleaning robot does not
dock onto the station
Cleaning robot has ab-
sorbed wet dirt
Cleaning robot makes a
creaking sound during the
cleaning process
Bad cleaning result
Cleaning robot blocked in
station
Internal or external short
circuit of the charger con-
tact strips
Display Consequence
Green Uneven cleaning
Perma-
nent light
Green Only a specific area/
Perma- location is cleaned
nent light
Green Station is place in an
Slowly unfavourable loca-
tion in the room
Green Cleaning robot is not
Slowly vacuumed
– The brush roller and
the flat filter in the
cleaning robot are
glued
– Bad cleaning result
– Brush roller worn
Station: The cleaning robot
All LEDs remains in the station
blink after the charging
process is complete.
Station: –
All LEDs
blink
– 15
EN
Remedy
This is normal on deep-
piled carpets > 20 mm.
Clean the dust sensors us-
ing a soft cloth or a soft
paintbrush.
Reposition the station, ob-
serve installation instruc-
tions.
Check the seating of the
cover of the dirt receptacle.
Place the station on a level
surface.
Install the access ramp of
the station.
Remove the brush roller
and the flat filter and clean
them thoroughly.
Caution: Do not install a
wet filter.
Brush roller is not seated
correctly.
Switch the cleaning robot
off and check its seating.
Replace the brush roller.
Remove the object blocking
the appliance. Switch the
station off and back on.
Contact authorised Cus-
tomer Service!
Contact authorised Cus-
tomer Service!
29