Teaching - HomeMatic HM-RC-Key3-B Bedienungsanleitung

the remote control is ready for operation. Depending
on the requirements, the battery may recover and
send again many times after a short break. If the
power drops too low when sending, the respective
error code is displayed again.

6.2 Teaching

Please read this section completely before starting
with any teaching!
The remote control supports three different modes
• Operation mode (normal operation)
• Configuration mode ( for changing remote control
parameters)
• Teach mode (Teaching HomeMatic components)
Training requires that both devices to be connected
are put into teach mode and the desired channel is
selected for training.
The teach button is located on the back of the
remote control in the bottom left. This button is
located within a recess in the housing so that it
cannot be pressed accidentally.
33