IKEA BEJUBLAD Handbuch Seite 14

ENGLISH
Problem
Acoustic signal sounds, ap-
pliance switches off.
Display is switching between
two power settings.
The residual heat indicator is
not displaying anything.
There is no signal when you
touch panel symbols.
lights up on the power
setting display.
symbol plus a number
appears on the power set-
ting display.
lights up on the power
setting display.
Possible cause
One or more symbols have
been covered for longer
than 10 seconds.
Power exchange function is
reducing the power of this
cooking zone.
The cooking zone was only
on for a short time and is
therefore not hot.
The signals are deactivated. Activate the signals. Refer to
Unsuitable cookware.
No cookware on the cooking
zone.
The diameter of the bottom
of the cookware is too small
for the cooking zone.
Electronics fault.
Overheating protection for
the cooking zone operates.
Remedy
Uncover symbols.
See the section "Power ex-
change function".
If the cooking zone is sup-
posed to be hot, call the Af-
ter Sales Service.
OffSound Control.
Use suitable cookware.
Place cookware on the cook-
ing zone.
Move onto a smaller cooking
zone.
Disconnect the appliance
from the electrical supply for
a few minutes. Take the fuse
out of the house's electric
system. If after switching on
again, is displayed
again, call the After Sales
Service.
Deactivate the appliance.
Remove the hot cookware.
After approximately 30 sec-
onds switch on the cooking
zone again. should dis-
appear, residual heat indi-
cator can stay. Cool down
the cookware and check it
with the section "Cookware
for the induction cooking
zones".
14