Werbung
OPERATION / BEDIENUNG / UTILISATION / OPERACIÓN / OBSŁUGA / UTILIZZO
EN
A few seconds after connecting to the power supply, the effects projector is ready for operation and the operating mode that was previously
selected is activated. During startup, the software version is briefly displayed (Vxxx).
ACTIVATING THE DMX CONTROL, THE DMX MODE AND DMX START ADDRESS
Press the MODE button repeatedly until "dMX" appears on the display. Now press ENTER to activate the DMX control and display the currently set
DMX start address. If no DMX signal is present, all four digits on the display will flash; if a DMX signal is present, the flashing stops and the DMX
LED will start flashing (DMX). Press the ENTER button and then use the UP and DOWN buttons as required to select the DMX operating mode (2Ch,
8Ch). Confirm with ENTER. The currently set DMX start address will be shown on the display and you can use the UP and DOWN buttons to make
adjustments as required (2Ch = 001 - 511, 8Ch = 001 - 505). To confirm, press ENTER. The synchronous control of multiple spotlights (same model)
through a DMX control unit (e.g. DMX console) can be achieved by selecting the same DMX mode and assigning the spotlights to an identical DMX
start address while connecting them using DMX cables.
-> ENTER ->
<- MODE
SLAVE MODE
Press the MODE button repeatedly until the LED indicator for the Slave mode (SLAVE) lights up and displays "SLA". Now press ENTER; the display will
indicate "SLAV" and the slave mode is activated. If no control signal is present, the digits on the display will flash; the flashing will stop and the DMX
LED will light up as soon as a control signal is present. Connect the slave and the master unit (same model) using a DMX cable (Master = DMX OUT,
Slave = DMX IN) and activate one of the standalone modes (automatic control or music control) on the master unit. Now the slave unit follows the
master unit.
-> ENTER ->
<- MODE
SYSTEM
In the System menu item, the display switch-off and a test program for all functions can be enabled and a reset of all settings can be performed.
Press the MODE button repeatedly until "SYS" appears on the display. Press the ENTER button and then use the UP and DOWN buttons to select the
desired menu item.
-> ENTER ->
<- MODE
System
LEdS
= Display switch-off
tESt
= Test program for all functions of the effects projector
(Derby LEDs, Laser R + G, motors)
rESt
= Reset to factory settings
AUTOMATIC CONTROL MODE
Press the MODE button repeatedly until the LED indicator for automatic control (AUTO) lights up and "Aut" appears on the display. Now press ENTER
to activate the automatic control and display the currently set auto program (Aut1 - Aut3). One of the 3 auto programs can now be selected by using
the UP and DOWN buttons. After confirming by pressing the ENTER button, you can now select the speed at which the selected program runs by
using the UP and DOWN buttons (the display shows: S 01 = minimum speed, S 99 = maximum speed). Confirm with ENTER.
-> ENTER ->
<- MODE
-> ENTER ->
<- MODE
UP/DOWN
UP/DOWN
UP/DOWN
-> ENTER ->
UP/DOWN
<- MODE
-> MODE, UP,
stop test
DOWN
-> ENTER ->
<- MODE
on
= display goes off after about 30 seconds of inactivity
oFF
= display switch-off disabled
stop the test
= press MODE, UP, or DOWN
program
start Reset
= press ENTER
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER
<- MODE
-> ENTER
<- MODE
21
Werbung
