Automatic Zero-Adjusting/ Stability And Response Settings (Function "Fnc 05") - KERN KXG-TM Etriebs- Und Installationsanleitung

10.5 Automatic zero-adjusting/ stability and response settings
(function "FnC 05")
This function is only available for unverified weighing systems (CFn 02 = 0),
for verified weighing systems see chapter 18.5.1.
 Call up function "FnC 05", see chapter 10 "Navigation in the menu".
 Press the TARE-key, current setting appears.
 Select desired settings with TARE or UNIT key.
Zero 0 Switch Automatic zero-adjusting switch on and off and select zero
range.

You can select 0 (switched off), 1d, 2d, 3d, 4d, 5d, 6d, 7d, 8d, 9d
Zero 9
 Confirm with TARE key, the current stability settings are indicated.
38 KXS/KXG-TM-BA_IA-e-1621