Notes On Safety - Parkside PWSA 18 A1 Betriebsanleitung

GB IE CY
Battery (Li-Ion) ........... PAP18-2.6A1
Number of battery cells................. .. 10
Nominal voltage ...................... 18 V
Capacity .................................. 2,6 Ah
Charging time ..........................ca. 1 h
Recharger ................ JLH-H260-18B
Nominal consumption ................. 70 W
Uptake voltage/Input
....................... 220-240 V~, 50-60 Hz
Voltage output/Output
.............................. 18 V
Protection class ............................
Protection category ...................... IPX0
The vibration values represent maximum
values which have been determined with
the supplied cutting disc. The actual vibra-
tion values may vary depending on the
used accessories. The vibration values are
still affected by the handling of the user's.
Cutting disc (extent of delivery):
Idling speed n
0
................................... max.13300 min
Disc speed ....................... max. 80 m/s*
Outer diameter ................... Ø 115 mm
Bore hole .......................... Ø 22,2 mm
Thickness ................................ 2,4 mm
*
The grinding disc must keep a rotational
speed of 80 m/s
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
Technical and optical changes may be
undertaken in the course of further devel-
opment without notice. All dimensions,
references and information in this instruc-
tion manual are therefore not guaranteed.
Legal claims made on the basis of the
instruction manual can therefore not be
6
considered as valid.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
2600 mA
II
-1

Notes on safety

Warning:
The vibration emission value whilst
actually using the electrical tool may
vary from the given values indepen-
dently of the type and way in which
the electric tool is used.
Safety measures for the protection of
the operator are to be determined
that are based on an estimate of the
actual exposure under the real oper-
ating conditions (for this, all parts of
the operating cycle are to be taken
into account, for example, times in
which the electric tool is turned off,
and those during which it is turned
on but running without a load).
Caution! When using power tools,
observe the following basic safety
measures for the prevention of elec-
tric shocks and the risk of injury and
fire.
Please read all these instructions be-
fore using this electric tool and please
keep the safety instructions.