Pairing Of Transmitter And Dive Computer - SubGear XP Air Gebrauchsanweisung

4.2 Pairing of transmitter and dive computer

To receive the data of the transmitter, the transmitter itself must be paired with XP AIR.
Pairing is necessary:
• before the first use of XP AIR with the transmitter;
• if you use a new transmitter or a new computer;
• after changing the battery.
Pairing procedure:
1. Shut the valve, depressurise the regulator and wait for 15 seconds.
2. Switch on XP AIR (bridge contacts B and E).
%
%
10 sec.
%
%
F
• Pairing of transmitter and dive computer may already be carried out at home and need only
be executed once, before the first use.
• You may delete the pairing of transmitter and dive computer by means of the Dive.Log
software.
3. Move the dive computer and transmitter into the shown
position.
F
Transmitter and dive computer must be in physical
contact during the entire pairing procedure.
4. Open the tank valve. The transmitter briefly sends a
pairing sequence to the computer.
5. The dive computer shows a flashing "PAIr" shortly after
the valve has been opened.
6. In order to confirm the pairing, the B and E contacts have to be bridged
with-in 5 sec. A beep confirms the input and the "PAIr" display remains
still.
7. "PAIr" disappears after approx. 10 sec.
In case of faulty pairing, the display "FAIL" appears instead of "PAIr". In that
case, completely purge the regulator and repeat the pairing procedure.
This is only possible after at least 15 seconds.
System and operation
13