SubGear XP Air Gebrauchsanweisung Seite 39

5. Remove the transmitter cap o-ring carefully. Do not damage the sealing surfaces.
6. Remove the battery by holding it on both sides. Do not touch the contacts or electronic parts.
F
Protect the environment and dispose the battery properly.
If you notice traces of seeping water, damages, or other defects on the o-ring, do not use the
transmitter for further dives. Take it to an authorized SUBGEAR dealer for check and repair.
7. Always insert a new o-ring when you replace the battery and dispose the old o-ring.
Make sure that the new, lubricated o-ring is in perfect condition, and that o-ring, o-ring groove and
the sealing surfaces of HP outlet and transmitter cap are free of dust and dirt.
If necessary, clean the parts with a soft cloth. Fit the o-ring in the o-ring groove.
8. Check the proper polarity of the battery. The transmitter can be damaged if you do not insert
the battery correctly.
Wait for at least 30 seconds. Now insert the new battery, with "+" pointing upwards, into the battery
compartment.
9. After battery replacement the transmitter will perform an automatic test and switch into ready mode
after 60 seconds.
10. The transmitter cap will only fit in one position. Check the proper position of the guide slots
on the electronic support and in the transmitter cap.
Slide the transmitter cap carefully back into its proper position.
11. Do not overtighten the screws! Fasten the transmitter cap with the 3 screws.
12. Mount the transmitter on the HP outlet of the first stage of the regulator and check transmission
and pairing. If you do not receive valid tank pressure data, transmitter and dive computer must be
paired again.
! WARNING
! WARNING
! WARNING
39