Switching On The Display; Checking The Battery Capacity; Selection And Activation Of User Functions - SubGear XP Air Gebrauchsanweisung

System and operation

2.3 Switching on the display

%
%
NO
CNS O %
2
%

2.4 Checking the battery capacity

Battery capacity

2.5 Selection and activation of user functions

Gauge mode ->27
Input microbubble level ->31
Input O
Logbook ->36
Dive planner ->34
After the selection of the desired function you can activate and deactivate it by bridging the
contacts B and E.
F
Details to the user functions are to be found on the pages mentioned above.
10
NO
NO
CNS O %
2
DECO STOP
LEVELSTOP
NO STOP
Temperature
O Mix
2
Do not fly icon
No-fly time
Oxygen toxicity
Desaturation time
After switching on XP AIR you can check the battery capacity by bridging
the contacts B and E. The remaining capacity is displayed for 3 seconds as
a percentage. If the value reaches 0%, the battery warning gets activated
(->17) and the battery has to be replaced by an authorised SUBGEAR
dealer.
For a 7-day diving vacation XP AIR uses between 2 – 5 % of its battery
capacity.
mix ->18
2
• automatically, on submerging in water or when
adaptation to atmospheric pressure is necessary;
• manually, by bridging contacts on housing (B-E).
• When XP AIR is in state of rest no information
is displayed but the atmospheric pressure is
continuously monitored. If a higher altitude range
is detected, XP AIR switches on for 3 minutes
automatically -> 26.
XP AIR switches on by bridging the contacts B and E.
All segments light up for 5 seconds.
Afterwards the display shows the selected O
temperature and in certain circumstances an altitude
range ->26.
If the transmitter is switched on and located within
transmitting distance, the tank pressure is displayed,
otherwise "---" will be displayed. If no transmitter has
been paired yet, the display will be blank.
If there is a remaining saturation due to the last dive or
change of altitude, XP Air also displays the remaining
desaturation time, the oxygen toxicity and the "no-fly
time" ->25.
At the surface you can select the dive planner, the logbook
and gauge mode as well as the functions to enter the O
mix and the microbubble levels by bridging the contacts
+ and B or – and B.
mix, the
2
%
2