Control Board - Futurelight PSC-575 DMX-Scanner Bedienungsanleitung

Control Board

The Control Board offers several features: you can simply set the starting address, switch on and off the
lamp, run the pre-programmed program or make a reset.
The main menu is accessed by pressing the Enter-button for 3 seconds until the display starts flashing.
Browse through the menu by pressing the Up-button. Press the Enter-button in order to select the desired
menu. You can change the selection by pressing the Up-button. Confirm every selection by pressing the
Enter-button. You can leave every mode by pressing the Exit-button. The functions provided are described in
the following sections.
Default settings shaded.
Main
Sub menu
menu
ADDR
0 MODE
RUN
DISP
OPEN
ONLI
1 LAMP
DELA
RPAN
RTIL
16BI
2 SET
REST
LODA
VER
LADJ
3 ADJU
TEST
MATI
LATI
4 TIME
CLMT
CLLT
STEP
SC01
5 EDIT
~
SC48
Extension
VALU A001~A511 (AXXX)
SLAV ON/ OFF
EBOC ON/OFF
AUTO ALON
MAST
SOUN ALON
MAST
VALU D–00 ~ D-30 (DXXX)
RDIS ON/ OFF
CLDI ON/OFF
ON/OFF
ON/OFF
D–00 ~ D-FF
ON/ OFF
ON/ OFF
ON/OFF
ON/ OFF
ON/ OFF
V-1.0~V-9.9
ON/ OFF
T–01 ~ T–30
0000~9999 (hours)
0000~9999 (hours)
ON/OFF
ON/OFF
S–01 ~ S–48
01XX (00~FFH)
C–01 ~ C–30
30XX (00~FFH)
TIME (sec.) T – – X (1~9)
CNIN ON/OFF
38/91
Display
DMX address setting
(SLAV)
Change DMX address via
external controller
Automatic Program Run
(AU-A)
Automatic Program Run
(AU-M)
Sound-controlled Program
(SO-A)
Run in Stand Alone
Sound-controlled Program
(SO-M)
Display the DMX 512 value
Shut off LED display
Lamp on/off via controller
Switch 16 bit/8 bit
Restore factory settings
Test function of each
Fixture running time
Lamp running time
Steps of Program Run
Edit the channels of each
Time for each scene
Edit program via controller
51839965X17NXS_V_1_0.DOC
Function
Slave setting
in Stand Alone
as Master
Run as Master
of each channel
Reverse display
Lamp on/off
Delay lamp on
Pan Reverse
Tilt Reverse
Reset
Software version
Lamp adjustment
channel
Clear fixture time
Clear lamp time
scene