Cleaning And Care; Self-Cleaning Function - Cleanmaxx SG 5008S-5 Gebrauchsanleitung

2. Place the device upright on its base and allow it to cool down completely.
3. Empty the water reservoir each time after you use the device. To do this, open the water
reservoir cover, hold the device over a sink or similar outlet and turn the device upside
down. The remaining water will now run out of the reservoir.
4. Clean the device in the manner described in the "Cleaning and Care" chapter.

Cleaning and Care

CAUTION!
❐ Remove the plug from the mains socket before cleaning the device.
❐ After use, the device may still be very hot. Allow the device to cool down completely be-
fore you empty the water reservoir and/or clean the device and store it away.
❐ Never immerse the device in water or other liquids!
❐ Never touch the device, the cable or the plug with wet hands.
❐ Do not use corrosive or abrasive cleaning agents or cleaning pads for cleaning. These can
damage the surface.
• Empty the water reservoir (see the "After Use" section).
• If necessary, wipe off the outside of the device with a soft, slightly damp cloth and dry it
with a soft cloth.

Self-Cleaning Function

If you do not use distilled water, perform the working steps which are described below regu-
larly (at least every 10 operating hours):
1. Move the steam quantity control to 0, move the temperature control to MIN and pull the
plug out of the plug socket.
2. Fill the water reservoir around half full with water (see the "Filling the Water Reservoir"
section). Ideally you should only ever use distilled water for self-cleaning.
3. Place the device upright on a stable, fl at and heat-resistant surface.
4. Plug the mains plug into a properly installed, easily accessible mains socket and move the
temperature control to position MAX.
5. Wait until the device has heated up and the temperature control lamp goes out.
6. Move the temperature control to position MIN.
7. Remove the mains plug from the mains socket.
8. Hold the device horizontally over a sink or similar outlet.
9. Press the Self Clean button (12).
10. Allow the water reservoir to run completely empty. Tilt the device back and forth slightly to
allow the water to run out of all nozzles.
11. If necessary, repeat the cleaning process several times until no more limescale residues
emerge from the nozzles.
08298_DE-GB-FR-NL_A5_V3.indb 24
24
02.04.2013 14:04:36