Dry-Ironing; Filling The Water Reservoir; Steam-Ironing - Cleanmaxx SG 5008S-5 Gebrauchsanleitung

Dry-Ironing

1. Move the steam quantity control (11) to position 0 and the temperature control (5) to
MIN. Turn the little wheel until MIN is next to the operating lamp.
2. Place the device to heat up upright on a stable, fl at and heat-resistant surface.
3. Plug the mains plug of the device into a properly installed mains socket that is easily acces-
sible. The operating lamp (4) lights up.
4. Check the label in the garment for the required ironing temperature and set this using the
temperature control. The temperature setting you want must be positioned next to the
operating lamp.
5. As the device heats up, the temperature control lamp (15) lights up. Wait until the device
has heated up and the temperature control lamp goes out. The device is now ready for use
and you can start ironing.

Filling the Water Reservoir

CAUTION!
❐ Always pull out the plug before you top up/empty the water reservoir. Always pull the plug
and never the cable.
❐ Never pour any cleaning agent or other additives into the device. This could destroy the
device and safe working is no longer guaranteed.
❐ Never exceed the maximum fi ll level (note MAX marking on the water reservoir!). The
useful service life of the device will be extended if you use pure distilled water.
1. Make sure that the device is not connected to the mains power. Move the steam quantity
control (11) to position 0 and the temperature control (5) to MIN. Turn the little wheel
until MIN is next to the operating lamp.
2. Open the water reservoir by opening up the water reservoir cover (10). Please note that the
cover cannot be completely detached from the device.
3. Place the device with the bottom of the iron (8) onto a fl at surface and tilt it back slightly so
that it stands on the rear edge of the housing.
4. Fill the reservoir up to the MAX marking (7) with the supplied measuring cup (17). The
reservoir holds approx. 350 ml.
5. Close the water reservoir by fl ipping the cover shut again. Make sure that the water res-
ervoir is completely sealed shut.

Steam-Ironing

CAUTION!
❐ Never aim the steam directly at people, animals or plants. This can cause severe scalding.
1. Fill up the water reservoir with water (see the "Filling the Water Reservoir" section).
2. Place the device to heat up upright on a stable, fl at, heat-resistant and moisture-resistant
surface.
08298_DE-GB-FR-NL_A5_V3.indb 22
22
02.04.2013 14:04:36