Pioneer PDP-503MXE Bedienungsanleitung Seite 15

Installation using the optional PIONEER stand or
installation bracket
÷ Please be sure to request installation or mounting of this unit
or the installation bracket by an installation specialist or the
dealer where purchased.
÷ When installing, be sure to use the bolts provided with the
stand or installation bracket.
÷ For details concerning installation, please refer to the
instruction manual provided with the stand or installation
bracket.
Installation using accessories other than the
PIONEER stand or installation bracket (sold
separately)
÷ When possible, please install using parts and accessories
manufactured by PIONEER. PIONEER will not be held
responsible for accident or damage caused by the use of parts
and accessories manufactured by other companies.
÷ For custom installation, please consult the dealer where the
unit was purchased, or a qualified installer.
b hole
a hole
b hole
b hole
Rear view diagram (PDP-503MXE)
a hole
b hole
b hole
Rear view diagram (PDP-433MXE)
Air vents (fan)
b hole
a hole
Center line
b hole
Air vents (fan)
a hole
Center line
b hole
Installation and Connections
Wall-mount installation of the unit
This unit has been designed with bolt holes for
wall-mount installation, etc. The installation holes that can
be used are shown in the diagram below.
÷ Be sure to attach in 4 or more locations above and
below, left and right of the center line.
÷ Use bolts that are long enough to be inserted 12 mm to
18 mm into the main unit from the attaching surface for
both a holes and b holes. Refer to the side view
diagram below.
÷ As this unit is constructed with glass, be sure to install
it on a flat, unwarped surface.
CAUTION
To avoid malfunction, overheating of this unit, and possible
fire hazard, make sure that the vents on the main unit are
not blocked when installing. Also, as hot air is expelled
from the air vents, be careful of deterioration and dirt build
up on rear surface wall, etc..
Main unit
Center line
b hole
12 mm to 18 mm
Side view diagram
CAUTION
Please be sure to use an M8 (Pitch = 1.25
mm) bolt. (Only this size bolt can be used.)
CAUTION
This display unit weighs at least 30 kg and
has little front-to-back depth, making it very
Center line
unstable when stood on edge. As a result,
b hole
two or more persons should cooperate
when unpacking, moving, or installing the
display.
CAUTION
This unit incorporates a thin design. To
ensure safety if vibrated or shaken, please
be sure to take measures to prevent the
unit from tipping over.
Attaching surface
Installation
bracket, etc..
a hole
Bolt
12 mm to 18 mm
Bolt
b hole
11
En