Connection To Input1 And Input2; Connection To A Personal Computer - Pioneer PDP-503MXE Bedienungsanleitung

Installation and Connections

Connection to INPUT1 and INPUT2

The INPUT 1 and INPUT 2 terminals are used to connect
the display to a computer. After making the connections,
adjust the screen settings in accordance with the
computer's signal output. See pages 17-18 for information
regarding settings.
INPUT2
[ON SYNC]
jack
G
Output
source
Personal
computer (PC)
SYNC ON G
with RGB output
G
G
: Do not connect anything.
Note
Components compatible with INPUT1 are also compatible with
INPUT2.
INPUT1 is compatible with Microsoft's Plug & Play (VESA DDC
1/2B).
When making connections to INPUT1, please refer to
supplement 2 on page 37.
For the screen sizes and input signals that
INPUT1 and INPUT2 are compatible with, please
refer to supplement 1 (pages 35 and 36).
12
En
[H/V SYNC]
B R HD VD
B R
B R H/V SYNC
B R HD VD
: Connect to this jack.
Connection to a personal
computer
Connection method differs depending on the computer
type. When connecting, please thoroughly read the
computer's instruction manual.
Before making connections, be sure to make sure that
the personal computer's power and this unit's main
power is off.
For the PC input signals and screen sizes that this unit is
compatible with, please refer to supplement 1 (pages 35
and 36).
Connection of separate SYNC analog RGB
source
Make separate SYNC connections for a personal
computer that has RGB output separated into 5 output
signals: green, blue, red, horizontal synchronization signal,
and vertical synchronization signal.
When connecting to INPUT2
INPUT2
(ON SYNC) (H/V SYNC)
G B R HD VD
When using INPUT2, set the impedance selector switch
to match the output impedance of the connected
computer's synchronization signal.
When the output impedance of the computer's
synchronization signal is below 75 Ω, set this switch to
the 75 Ω position.
On-screen setup is necessary after connection.
Please see pages 17 and 18.
75 2.2
Ô
Ω
kΩ