Installation - Ferm BGM1008 Gebrauchsanweisung

GB
Always check that the power supply corresponds to the voltage on the rating plate.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The minimum
conductor size is 1.5 mm 2 . When using a cable reel always unwind the reel completely.

3. INSTALLATION

The grinder must be firmly bolted to a workbench. The length of the fixing bolts will depend on
the thickness of the workbench. If the workbench is made of steel, it is advisable to use a
wooden block or plank between the grinder and the bench, to insulate it and prevent vibration.
Mounting and adjustment of eye shield bracket and eye shield
Fig. B
The eye shield bracket and eye shield should only ever be assembled/adjusted
with the grinding wheel stationary, and the machine disconnected from the power
supply.
• Mount the eyeshield bracket together with the eye shield itself, by means of the screw (A).
• Adjust the height of the eyeshield bracket of the eyeshield by loosening a bit screw . The
free space between the stone and the eyeshield bracket of the eyeshield will amount to
1 - 1,5 mm.
• Fasten well screw (A).
• Adjust the eyeshield in such a way that your face will be protected, at the utmost.
• Use always safety glasses.
Adjusting tool rest
Fig. B
The tool rest should only be adjusted when the grinding wheel is completely statio-
nary, and the machine is disconnected from the power supply (the wall socket).
Secure the tool rest, allowing a maximum clearance (C) between the tool rest and the grinding
stone of 1 -1.5 mm.
Replacing the grinding stone
Fig. C
Required tools:
• 19 mm Spanner
• 8 mm Spanner
• Screwdriver
6
Defekte og/eller kasserede elektriske eller elektroniske maskiner skal afleveres på
en genbrugsplads.
Garanti
Læs det separat vedlagte garantikort for garantibetingelserne.
CE
Vi erklærer herved, udelukkende på eget ansvar, at dette produkt opfylder følgende standarder
EN55014-1, EN55014-2, EN61000-3-2, EN61000-3-3, EN61029-1, EN61029-2-4
Fra 01-03-2009
ZWOLLE NL
J.A. Bakker - van Ingen
CEO Ferm BV
Det er vores hensigt til stadighed at forbedre vores produkter, og vi forbeholder os derfor til
enhver tid retten til at ændre produktspecifikationerne uden forudgående varsel.
Ferm BV • Lingenstraat 6 • 8028 PM Zwolle • Holland
Ferm Ferm
KONFORMITETSERKLÆRING (DK)
eller standardiserede dokumenter:
i overenstemmelse med direktivreglerne
98/37/EEC, 73/23/EEC, 2004/108/EC
J.F.J. Strikkers
Senior Quality Manager
DK
79