Inhaltsverzeichnis
Werbung
UK
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The minimum
conductor size is 1.5 mm
2
. When using a cable reel always unwind the reel completely.
3.
INSTALLATION
The grinder must be firmly bolted to a workbench. The length of the fixing bolts will depend on
the thickness of the workbench. If the workbench is made of steel, it is advisable to use a
wooden block or plank between the grinder and the bench, to insulate it and prevent vibration.
Mounting and adjustment of eye shield bracket and eye shield
Fig. B
The eye shield bracket and eye shield should only ever be assembled/adjusted
with the grinding wheel stationary, and the machine disconnected from the power
supply.
•
Mount the holder of the cover glass together with the cover glass itself, by means of the
screw (A).
•
Adjust the height of the holder of the cover glass by loosening a bit screw . The free space
between the stone and the holder of the cover glass will amount to 1 - 1,5 mm.
•
Fasten well screw (A).
•
Adjust the cover glass (see the figure above) in such a way that your face will be protected,
at the utmost.
•
Use always safety glasses.
Adjusting tool rest
The tool rest should only be adjusted when the grinding wheel is completely statio-
nary, and the machine is disconnected from the power supply (the wall socket).
Secure the tool rest, allowing a maximum clearance (C) between the tool rest and the grinding
stone of 1 -1.5 mm.
Replacing the grinding stone
Fig. C
Required tools:
•
19 mm Spanner
•
8 mm Spanner
•
Screwdriver
Only ever replace the grinding wheel when the motor is at a standstill and the power
is completely disconnected.
•
Remove the guards, using the above tools. When replacing the stones, remember the
right-hand spindle is fitted with right-hand thread, the left-hand spindle with left-hand
thread.
6
CE
Vi erklærer herved, udelukkende på eget ansvar, at dette produkt opfylder følgende standarder
EN55014-1, EN55014-2, EN61000-3-2, EN61000-3-3, EN61029-1, EN61029-2-4
Fra 01-10-2005
ZWOLLE NL
W. Kamphof
Quality department
Det er vores hensigt til stadighed at forbedre vores produkter, og vi forbeholder os derfor til
enhver tid retten til at ændre produktspecifikationerne uden forudgående varsel.
Ferm BV • Lingenstraat 6 • 8028 PM Zwolle • Holland
Ferm
Ferm
KONFORMITETSERKLÆRING (DK)
eller standardiserede dokumenter:
i overenstemmelse med direktivreglerne
98/37/EEC, 73/23/EEC, 89/336/EEC
DK
79
Werbung
Inhaltsverzeichnis
