Ferm MSM1031 Originalbetriebsanleitung Seite 5

19. Flange
20. Screw
21. Extension pieces (left and right)
22. Lock-button saw blade
23. Bolts
24. On/off switch for laser
Package contents
1 Radial mitre saw
1 Dust bag
1 Clamp
1 Key for changing the saw blade
3 Support bar
1 Instructions for use
1 Safety instructions
1 Warranty card
Check the machine, loose parts and accessories
for any transport damage.
2. Safety
When using the machine, always
carefully follow the safety precautions
supplied and the safety instructions given
below.
Explanation of the symbols
Danger of bodily injury or material
damage.
Indicates electrical shock hazard.
Class ll machine. Your machine is double
insulated; therefore no earthwire is
required.
Keep bystanders at a distance
Wear eye and ear protectors
Before each use of the saw
Check the machine. If any part of the machine is
missing, bent or in any other way unusable, or
when an electrical defect occurs, turn the machine
off and take the plug out of the socket. Replace all
missing, damaged or defective parts before using
the machine again.
To fix the saw blade in the slot and to prevent
the piece of work from moving, follow the
instructions below.
• Choose a suitable saw blade for the work.
Use the crosscut saw only for sawing wood
and wood derivatives or light metal such as
aluminium. Other materials can jump away or
get caught in the saw blade or give rise to
other dangers.
• The arrow marked on the saw blade, which
indicates the direction of rotation, must point
in the same direction as the arrow marked on
the machine. The saw blade teeth must point
downwards on the front of the saw.
• Check that the saw blade is sharp,
undamaged and correctly aligned. After
unplugging the machine, push the saw hood
downwards. Rotate the saw blade by hand
and check that it revolves freely. Put the
machine in the 45° position and check free
rotation again. If the blade touches anything it
must be adjusted.
• Keep the saw blade and the clamping surface
for the clamps clean.
• The saw blade flange must always be
mounted with the notch tightened towards the
saw blade.
• Check that all tensioning devices and locks
are secure and that no part has too much play
in it.
• Never just use your hands for sawing.
• Always press the piece of work firmly against
the stop, so that it cannot tilt or turn while
sawing. No impurities must gather underneath
the piece of work being sawn.
• Make sure that the piece of work cannot move
after being sawn, for example because it is
not completely supported by the surface of
the machine.
• For sawing pieces of work that are not
supported by the full surface, use some
padding or another machine.
• Replace any worn-out table inserts.
• Only use saw blades recommended by the
manufacturer (EN-847-1).
• Never use HS (High Speed) saw blades.
• Check that the sawn off bits can be removed
sideways from the saw blade, otherwise they
can get caught on the blade and flung about.
EN
5