Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Note! Let the HEPA filter dry but keep it
away from any sources of light or heat.
Insert only the dry HEPA filter back into
the machine.
 Replace the HEPA filter if found to be
damaged.
 Clean the HEPA filter regularly at inter-
vals of 4 months.
 Ensure that the HEPA filter (15) is posi-
tioned correctly in the holders. Then
block the lever (16). (Fig. 12).
Caution!
 Do not clean the HEPA filter using a
brush as it can get damaged and its fil-
tering capacity can get reduced.
 Do not use any cleaning agents, do not
rub the HEPA filter and do not clean it in
the dish-washer.
 HEPA filters are available with the au-
thorised Customer Service agents.
Spare parts
Use only original KÄRCHER spare parts.
You will find a list of spare parts at the end
of these operating instructions.

Troubleshooting

Often, failures have simple causes and you
can do the troubleshooting yourself using
the following overview. If you are in doubt
or if the failure is not listed here please con-
tact the authorized customer service.
Danger
Always disconnect the mains plug and al-
low the steam cleaner to cool down before
performing any maintenance work.
Repair works may only be performed by the
authorized customer service.
22
Vacuum cleaning does not start
There is no mains supply.
 Check the mains plug and mains socket.
Poor vacuum cleaning
Nozzle, suction hose or suction pipe
may be blocked.
 Clean the water filter inlay. Remove
blocks, if any, from the tubes and ac-
cessories.
 Change the water in the water filter con-
tainer.
HEPA filter worn out.
 Replace the HEPA filter.
Poor cleaning performance
Water in the water filter container is
very dirty.
 Change the water in the water filter con-
tainer.
Water leaks out while sucking in
The float switch is blocked.
 Clean the lid of the water filter container.
The vacuum cleaner does not suck
Float switch is blocking.
 Switch off the vacuum cleaner, ensure
that the water level in the reservoir is
correct and switch on the machine
again.
– 12
EN
fluids

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis