Menu "User Settings; A) Function G1 "Program Select - Sygonix tx.5 Bedienungsanleitung

9. Menu "USER SETTINGS"

• Briefl y push the "MENU" button (4) as described in chapter
8. b). The bottom-most display line shows "USER SETTINGS".
• Use the "–" (3) and "+" (2) buttons to switch between "USER
SETTINGS" and "INSTALL SETTINGS".
Select "USER SETTINGS" and then push the button "OK" (5).
• Then the buttons "–" (3) and "+" (2) can be used to select the
desired function (see following subchapters or short descrip-
tion in chapter 8. b).
• Confi rm the selection with "OK" (5).
• If you want to leave a function or the setting menu, push
the button „MENU" (4).

a) Function G1 "PROGRAM SELECT"

The room thermostat has 3 independent memories for switching
times/temperatures.
If you want to use different programmes depending on season
(e,.g. for alternating control of a heating or cooling device, see
information in chapter 7), you can store the respective matching
times/temperatures in slots 1, 2 and 3.
1. After selecting this function G1 "PROGRAM SELECT" and
confi rming with "OK" (5), the memory slot number (1, 2 or 3)
fl ashes in the display.
2. Select one of the 3 memory slots with the buttons "–" (3) and
"+" (2).
3. Confi rm the selection with "OK" (5).
The room thermostat is then in the previous menu for selec-
tion of functions again.
4. To leave the menu and return to the regular display, push the
button "MENU" (4), repeatedly if required.
59