Care And Cleaning; External Cleaning - ZANKER KDT 10032FK Benutzerinformation

Before starting a programme
Make sure that:
• The filters are clean and correctly installed.
• The cap of the salt container is tight.
• The spray arms are not clogged.
• There is dishwasher salt and rinse aid (unless you
use multi- tablets).
• The position of the items in the baskets is correct.
• The programme is applicable for the type of load
and for the degree of soil.
• The correct quantity of detergent is used.

Care and cleaning

Warning! Before maintenance,
deactivate the appliance and disconnect
the mains plug from the main socket.
Cleaning the filters
C
• Make sure that there are no residues of food or soil in or around the edge of the sump.
• Put back in place the flat filter (C). Make sure that it is correctly positioned under the 2 guides.
• Reassemble the filters (A) and (B).
• Put back the filter (A) in the flat filter (C). Turn it clockwise until it locks.
An incorrect position of the filters can cause bad washing results and damage to the appliance
Cleaning the spray arms
Do not remove the spray arms. If the holes in the spray
arms are clogged, remove remaining parts of soil with a
thin pointed object.
Unloading the baskets
1. Let the tableware cool down before you remove it
from the appliance. Hot items can be easily
damaged.
2. First remove items from the lower basket, then from
the upper basket.
At the end of the programme water can
still remain on the sides and on the door
of the appliance.
Dirty filters and clogged spay arms
decrease the washing results. Make a
check regularly and, if necessary, clean
them.

External cleaning

• Clean the appliance with a moist soft cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive cleaning
pads or solvents.
B
A
13