Care And Cleaning; Troubleshooting - ZANKER KDV10000FA Benutzerinformation

Care and cleaning

Warning! Before maintenance, deactivate the
appliance and disconnect the mains plug from
the mains socket.
Dirty filters and clogged spray arms decrease the
washing results.
Make a check regularly and, if necessary, clean them.
Cleaning the filters
1
3
To remove filters (B) and
(C), turn the handle
counterclockwise and re-
move. Pull apart filter (B)
and (C). Wash the filters
with water.

Troubleshooting

The appliance does not start or it stops during opera-
tion.
Before you contact the Service, refer to the information
that follows for a solution to the problem.
24
C
B
A
2
A
4
Remove filter (A). Wash
the filter with water.
D
A
5
Before you put the filter
(A) back, make sure that
there are no residues of
food or soil in or around
the edge of the sump.
Make sure that filter (A)
is correctly positioned
under the 2 guides (D).
An incorrect position of the filters can cause bad
washing results and damage to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, remove re-
maining parts of soil with a thin pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abrasive prod-
ucts, abrasive cleaning pads or solvents.
Internal cleaning
If you regularly use short duration programmes, these
can leave deposits of grease and limescale inside the
appliance.
To prevent this, we recommend to run long duration
programmes at least 2 times per month.
With some problems, different indicators flash con-
tinuously or intermittently at the same time to
show an alarm code.
6
Assemble filters (B) and
(C). Put them back in fil-
ter (A). Turn the handle
clockwise until it locks.