Basic Settings Of The Pa 3100 Hv; Calling Up And Operating The Menu - T+A PA 3100 HV Betriebsanleitung

In the Configuration menu general device settings are adjusted. This menu is described in detail in the following chapter.
Calling up and operating
the menu
52

Basic settings of the PA 3100 HV

(Configuration menu)

Briefly press the
the remote control handset to call up the menu.

When you open the menu, the following Select points appear on the screen:
* Only visible if a PS 3000 HV is connected.
Using the front-panel controls:

The VOLUME knob is used to select any point within the menu system.

To change a selected menu item, press the VOLUME knob to confirm your
choice, then adjust the value by rotating the knob.

After making the adjustment, press the VOLUME knob again to adopt the new
setting.

You can interrupt the process at any time by pressing the
case any changes you have made are discarded.

Holding the VOLUME knob pressed in takes you one level higher in the menu
system.


Press the button again to quit the menu.
Using the remote control handset:

Use the  /  buttons to select an item in the menu.

If you wish to change a selected menu item, first press the  button,
and then use the  /  buttons to alter it.

After making the change, press the  button again to accept the new
setting.

You can press the  button at any time to interrupt the process; the
change is then abandoned.

Press the  button again to leave the menu.
 -button on the front panel or long on the  button on

button; in this