T+A PA 3100 HV Betriebsanleitung Seite 64



Loudspeaker and signal
cables
Mains cables and mains
filters
Changing the batteries:
Disposing of exhausted
batteries
Care of the unit
Storing the unit
64
We recommend the use of the  'POWER THREE' ready-to-use mains cable
and the 'POWER BAR' mains distribution panel which is fitted with a phase
indicator as standard.
When you have completed the wiring of the system switch the system on.
Switch on the loudspeaker outlet to which your speakers are connected and
switch the integrated amplifier to the listening source which you wish to hear.
You should now hear the music.
If you encounter problems when setting up and using the integrated amplifier for
the first time please remember that the cause is often simple, and equally
simple to eliminate. Please refer to the section of these instructions entitled
'Trouble shooting'.
Loudspeaker cables and signal cables (inter-connects) have a significant
influence on the overall reproduction quality of your sound system, and their
importance should not be under-estimated. For this reason  recommends
the use of high-quality cables and connectors.
Our accessory range includes a series of excellent cables and connectors
whose properties are carefully matched to our speakers and electronic units,
and which harmonise outstandingly well with them.
For difficult and cramped situations the  range also includes special-length
cables and special-purpose connectors (e. g. right-angled versions) which can
be used to solve almost any problem concerning connections and system
location.
The mains power supply provides the energy which your sound system
equipment needs, but it also tends to carry interference from remote devices
such as radio and computer systems.
Our accessory range includes the specially shielded 'POWER THREE' mains
cable and the 'POWER BAR' mains filter distribution board which prevent
electro-magnetic interference from entering your Hi-Fi system. The reproduction
quality of our systems can often be further improved by using these items.
If you have any questions regarding cabling please refer to your specialist 
dealer who will gladly give you comprehensive expert advice without obligation.
We would also be happy to send you our comprehensive information pack on
this subject.
Remove the screw marked in the figure below, to open the battery
compartment, then withdraw the cover. Insert two new cells of the LR 03
(MICRO) type, taking care to maintain correct polarity as shown. Please note
that you must always replace all the cells.

Caution!
Batteries shout not be exposed to excessive heat like sunshine, fire or the like.

Exhausted batteries must never be thrown into the household waste! They
should be returned to the battery vendor (specialist dealer) or your local toxic
waste collection point, so that they can be recycled or disposed in a proper way.
Most local authorities provide collection centres for such waste, and some
provide pick-up vehicles for old batteries.
Disconnect the mains plug at the wall socket before cleaning the case.
The surfaces of the case should be wiped clean with a soft, dry cloth only.
Never use solvent-based or abrasive cleaners!
Before switching the unit on again, check that there are no short-circuits at the
connections, and that all cables are plugged in correctly.
If the device has to be stored, place it in its original packaging and store it in a
dry, frost-free location. Storage temperature range 0...40 °C