Volume Control And Menu Operation; Headphones Outputs; Source Selection; Tone And System Settings - T+A HA 200 Bedienungsanleitung

4

Volume control and menu operation

VOLUME
SELECT / OK
5

Headphones outputs

OUT1 ... OUT3
6

Source selection

ANALOG
USB
AES
S/P-DIF
OPT
BT
BNC
HDMI
ARC
7

Tone and system settings

TONE
LOUDN
MENU
8

Remote control receiver

*„Pentaconn" is a registered trademark of NIPPON DICS Co, Ltd. and complies with RC-8141C JEITA standard.
The desired volume can be set by turning this control knob. The currently set value is
shown in the display.
A brief press on the knob mutes the output.
In addition to volume control, this control knob is also used to configure the menus
for system settings and tone controls.
Output sockets for stereo headphones with a minimum impedance of 10 Ohm. Con-
nection via a balanced Pentaconn* jack plug 4.4 mm, a balanced XLR 4-pin connector
or a standard jack plug 6.35 mm.
The outputs can be switched on and off using the buttons.
The status LEDs above the buttons indicate which output is currently active.
To operate two outputs in parallel, press and hold the corresponding button until the
second output switches on.
It is possible to operate two headphones in parallel. When using two headphones, the
j
impedance per headphone must be at least 20 ohms.
Selects the analog inputs Analog IN 1 (RCA) and Analog IN 2 (XLR) To switch between
Analog RCA and Analog XLR, press the button twice if necessary.
Selects the digital inputs USB IN and AES / EBU.
Press the button again to switch between the two inputs.
Selects the coaxial digital inputs S/P DIF 1 and 2
Press the button again to switch between 1 and 2.
Selects the optical TOSLINK digital inputs Optical 1 and Optical 2.
Press the button again to switch between 1 and 2.
Selects the Bluetooth connection and the digital BNC input.
Press the button again to switch between the two inputs.
Selects the digital inputs HDMI 1, HDMI 2 or the return channel ARC.
To switch between the inputs, press the button repeatedly if necessary.
Switches the tone control (TONE) and loudness function (LOUDN) on and off.
• A brief press: Switches the tone control (bass and treble) on and off.
• A long press: Switches the loudness function on and off.
• A brief press of this button opens and closes the tone control menu.
(see chapter System and tone settings)
• A long press opens and closes the system settings menu.
(see chapter System and tone settings)
When operating by remote control, please point FM8 in the direction of the receiver.
37