Connecting The Appliance; Switching On The Appliance; Selecting The Temperature; Operating Tips - Bosch KIF20A50 Gebrauchsanleitung

Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current
via a correctly installed earthed socket.
The socket must be fused with a 10 A to
16 A fuse.
If the appliance is to be operated
in a non European country, check
on the rating plate whether the
indicated voltage and current type
correspond to the values of your
mains supply. The rating plate
is situated in the bottom left hand side
of the appliance. The mains
connection cable may be replaced by
an electrician only.
Warning!
!
Never connect the appliance
to electronic energy saver plugs or to
power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).
Switching on the
appliance
Fig. 2
Press the On/Off button 1.
Display 4 indicates the set temperature in
the refrigerator compartment. Displays 3
cold/fresh" come on.
When the door is opened, the interior light
comes on.

Selecting the temperature

Selecting the temperature for the
refrigerator compartment
The temperature has been set to +4 °C at
the factory.
To set the temperature, press button 2 for
at least 1 sec.
Repeatedly press or hold down the button
until the required temperature
is displayed.
We recommend a setting of +4 °C.
Perishable food should not be stored
warmer than +4 °C.
The temperature in the cool fresh"
compartment 1/B has been set to almost
0 °C at the factory and should not be
changed if at all possible. If frost forms on
the refrigerated food, the temperature can
be increased. (See Eliminating minor
faults yourself").

Operating tips

While the refrigerating unit is running,
condensation or frost forms on the rear
panel of the refrigerator and cool fresh"
compartments. This is quite normal.
It is not necessary to wipe off the
condensation or frost. The rear panel
defrosts automatically. The condensation
runs into the drainage channel Fig. 3 and
then to the refrigerating unit where
it evaporates.
en
21