First Use; Set The Water Softener - Progress pvs1530 Benutzerinformation

66 progress
Factory setting: audible signals activated
It is possible to deactivate the audible
signals.
Deactivation/activation of the audible
signals
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Press and keep pressed the programme
selection/RESET button until programme
light A flashes and programme light B
comes on with a fixed light.
3. Press programme selection/RESET but-
ton again, programme light A comes on
with a fixed light and programme light B
starts flashing. Wait until programme light
A goes off, programme light B goes on
flashing and the End indicator light is on

First use

Before using your dishwasher for the first
time:
• Ensure that the electrical and water con-
nections comply with the installation in-
structions
• Remove all packaging from inside the ap-
pliance
• Set the water softener level

Set the water softener

The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
The higher the content of these minerals and
salts, the harder your water is. Water hard-
ness is measured in equivalent scales, Ger-
man degrees (dH°), French degrees (°TH)
and mmol/l (millimol per litre - international
unit for the hardness of water).
Water hardness
°dH
51 - 70 91 - 125
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
°TH mmol/l
9,1 - 12,5
76 - 90 7,6 - 9,0
65 - 75 6,5 - 7,5
51 - 64 5,1 - 6,4
40 - 50 4,0 - 5,0
33 - 39 3,3 - 3,9
26 - 32 2,6 - 3,2
with a fixed light. This indicates that you
have activated the function for deactivat-
ing/activating the audible signals. The
fixed light of the End indicator light means
that the audible signals are activated.
4. 4. To deactivate the audible signals,
press the programme selection/RESET
button again, the End indicator light goes
off indicating that the audible signals are
deactivated.
5. 5. To memorize the operation, switch off
the dishwasher by pressing the On/Off
button.
• To activate again the audible signals sim-
ply follow the above operations until the
End indicator light comes on.
• Pour 1 litre of water into the salt container
and then fill with dishwasher salt
• Fill the rinse aid dispenser
If you want to use combi detergent
tablets such as: '3 in 1', '4 in 1', '5 in
1' etc. follow the instructions given
in 'Use of detergent'.
The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.
The water softener must be set in two
ways: manually, using the water hard-
ness dial and electronically.
Adjusting the water hardness setting
manually
2
2
2
2
2
2
1
Use of
electronically
level 10
level 9
level 8
level 7
level 6
level 5
level 4
salt
yes
yes
yes
yes
yes
yes
yes