Use Of Dishwasher Salt - Progress pvs1530 Benutzerinformation

Water hardness
°dH
11 - 14
4 - 10
< 4
Setting manually
The dishwasher is factory set at position
2.
1. Open the dishwasher door.
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position
1 or 2 (see chart).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Press and keep pressed the programme
selection/cancel button until programme
light A flashes and programme light B
comes on with a fixed light. Wait until pro-
gramme light B goes off. The programme

Use of dishwasher salt

Warning!
Only use salt specifically designed for use in
dishwashers. All other types of salt not spe-
cifically designed for use in a dishwasher, es-
pecially table salt, will damage the water soft-
ener. Only fill with salt just before starting one
of the complete washing programmes. This
will prevent any grains of salt or salty water,
which may have been spilt, remaining on the
bottom of the machine for any period of time,
which may cause corrosion.
°TH mmol/l
19 - 25 1,9 - 2,5
7 - 18 0,7 - 1,8
< 7 < 0,7
Adjusting the water hardness setting
manually
1
1
1
light A goes on flashing and simultane-
ously the End indicator light starts flash-
ing. Wait until programme light B goes off.
the programme light A goes on flashing
and simultaneously the End indicator
light starts flashing. This indicates that
you have activated the electronic setting
function of the water softener. The cur-
rent level is indicated by the number of
flashes of the End indicator light and a
pause of a few seconds.
Examples:
5 flashes, pause, 5 flashes, pause, etc. =
level 5
6 flashes, pause, 6 flashes, pause, etc. =
level 6
3. To change the level, press the pro-
gramme selection/cancel button. Each
time the button is pressed the level
changes. (For the selection of the new
level see the chart).
Examples:
if the current level is 5, by pressing pro-
gramme selection/cancel button once,
level 6 is selected,
if the current level is 10, by pressing pro-
gramme selection/cancel button once,
level 1 is selected.
4. To memorize the operation, switch off the
dishwasher by pressing the On/Off but-
ton.
To fill:
1. Open the door, remove the lower basket
and unscrew the cap of the salt container
by turning it anticlockwise.
2. Pour 1 litre of water into the container
(this is necessary only before filling
with salt for the first time) .
3. Using the funnel provided, pour in the salt
until the container is full.
progress 67
Use of
electronically
level 3
level 2
level 1
salt
yes
yes
no