Startup / Operation - BOMANN VSE 339 Bedienungsanleitung

In consideration of the shown distanc-
es, hold the guide (a) at the top and
bottom inside of the furniture door; mark
the positions of the drill holes. After
drilling, fix the guide with the screws
provided.
Insert the cover (c) until it clicks in the
guide (a).
Fully open the appliance and furniture
door and join them together. Slide the
bracket (b) in the guide (a) and mark
the drill holes. Remove the bracket and
drill Ø 2 mm holes with about 8 mm
distance to the outer door edge. Put the
bracket on again; secure it with the
screws provided.
If an aligning of the furniture door is
necessary, use the slot spacing. Check
if the door is arranged vertical as well
as horizontal, so that a smooth opening
and closing of the door is ensured.
Insert the cover (D) until it clicks on the
angle (B).

Startup / Operation

Startup / Operation Startup / Operation Startup / Operation
Prior to first use Prior to first use Prior to first use Prior to first use
CAUTION: : : : CAUTION
CAUTION CAUTION
After transport, the appliance should be left standing
upright for about 4 hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
Starting the appliance Starting the appliance
Starting the appliance Starting the appliance
• Connect the appliance to the power supply.
• Operate the temperature control. See also the
following section "Settings".
Settings Settings
Settings Settings
Setting [0] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [1–7] regulates the different values
of the internal temperature.
Setting 0 Set Set Set ting 0 ting 0 ting 0 Setting 1 Setting 1 Setting 1 Setting 1
Off state Lowest setting
(warmest inside
temperature)
Note that the temperature will change depending on
the ambient temperature, frequency of door opening
and the amount of food in the appliance.
During initial operation, turn the temperature control
to the highest setting first, until the appliance has
reached the desired operating temperature. After-
wards it is recommended to turn the control back to a
medium setting; correcting the temperature at a later
point would then be easier.
Interior light Interior light Interior light Interior light
When opening the appliance door, the interior light
will turn on automatically.
Storing food Storing food Storing food Storing food
NOTE: Recommendation! NOTE: Recommendation!
NOTE: NOTE: Recommendation! Recommendation!
To guarantee that the temperature is low enough,
you should pre-cool the appliance a few times before
initial loading foods.
CAUTION: CAUTION:
CAUTION: CAUTION:
Always pay attention to the storage instructions on
the sales packaging.
18
Setting 7 Setting 7 Setting 7 Setting 7
Highest setting
(coldest inside
temperature)