Troubleshooting - BOMANN VSE 339 Bedienungsanleitung

• Remove for that the appliance content and stor-
age at a cool location.
• Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
• After everything was thoroughly dried, you can
restart the operation.
Defrosting Defrosting
Defrosting Defrosting
The appliance has an automatic defrosting system.
During defrosting water drops drains off at the back
of the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate. Make
sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
Before you contact an authorized specialist Before you contact an authorized specialist Before you contact an authorized specialist Before you contact an authorized specialist
Problem Problem Possible cause Possible cause
Problem Problem Possible cause Possible cause
The appliance is - Is the unit not connected to mains power?
not working - Is the temperature properly set?
properly or at all - Is the place unqualified?
- Does the content prevent the appliance
door from closing properly?
- Are the ventilation openings clear of ob-
struction?
The content is - Is the temperature set properly?
too warm - Was the appliance door open for an ex-
tended period?
- Was large quantity of food placed in the
appliance within the last 24 hours?
- Is the appliance near a heat source?
Loud noise dur- - Does the appliance not stand vertical or
ing operation horizontal?
Water on the - Is the temperature set properly?
bottom - Is the water discharge channel / opening
blocked?
CAUTION: : : : CAUTION
CAUTION CAUTION
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
A defect evaporator can cause serious damage.
Reverse the bulb Reverse the bulb Reverse the bulb Reverse the bulb
Lamp specifications: 220- - - - 240 V Lamp specifications: 220
Lamp specifications: 220 Lamp specifications: 220
• Unscrew the screw of the lamp cover.
• Press on the lamp cover and remove it to the
back.
• Replace the defective bulb.
• Reattach the lamp cover and tighten the screw.
• Reconnect the appliance and switch on.

Troubleshooting

Troubleshooting
Troubleshooting Troubleshooting
Solution Solution
Solution Solution
- Insert the plug properly in the contact socket.
Check the fuse.
- Check the temperature setting.
- Check the ambient temperature.
- Check the appliance content.
- Unblock the ventilation openings, install the
appliance freely.
- Check the temperature setting.
- Open the door only as long as necessary.
- Set a colder temperature.
- Check the location (see "Installation").
- Check the appliance position.
- See the section "Operating noise".
- Check the temperature setting.
- Clean the water discharge channel / opening.
20
240 V~ ~ ~ ~ , max. 15 W , max. 15 W
240 V 240 V , max. 15 W , max. 15 W