IKEA SMAKOKA Handbuch Seite 13

ENGLISH
- You can find specific local regulations
for some countries in the paragraph
"Reference to Local Regulations". If no
information concerning your Country is
given, please ask details to a qualified
technician.
- The connection of the hob to the gas
pipe network or gas cylinder must be
made by means of a rigid copper or
steel pipe with fittings complying with
local regulations, or by means of a
continuous-surface stainless steel hose
complying with local regulations. The
maximum length of the hose is 2 linear
metres.
C
C
- Connect elbow (A) or (B) supplied with to
- Washer (D) not supplied with the product.
- IMPORTANT: if a stainless steel hose
- After connection to the gas supply, check
Electrical connection
- This operation must be performed by a
- The electrical connections must comply
- The earthing of this appliance is
A
- Do not use an extension cord.
- IMPORTANT: the data relevant to the
D
B
D
the hob inlet main pipe and interpose the
washer (C) supplied, in compliance with
EN 549.
is used, it must be installed so as not to
touch any mobile part of the furniture.
It must pass through an area where
there are no obstructions and where it is
possible to inspect it on all its length.
for leaks with soapy water. Light up the
burners and turn the knobs from max
position to minimum position
check flame stability
WARNING
qualified technician.
with local regulations.
compulsory by law.
voltage and power absorption are
indicated on the rating plate.
13
to
L
Earth
(yellow/green)
N