Operation By Showme Button - Kindermann QuickSelect 3.0+ Installations- Und Bedienungsanleitung

In order to define the parameters, first insert the commands for ‚Power On' and for ‚Power Off' into the
corresponding command lines, either using hexadecimal format or ASCII format. In the pulldown behind
the command you can choose how often this command will be repeated each time sent next, specify if
the "end of line" code must be sent or not (send CR / No CR, CR=Carriage Return). Using the ‚Timer/s'
fields an individual timeout between 0-9999 seconds can be assigned to both, the power-on and power-
off commands. By the field ‚Baud Rate' the communication speed can be set in accordance to the display
device used. Please refer to the user manual of your display device for all necessary commands, syntax
and parameters. ‚Stop Bits' and ‚Parity' can not be changed.
If the Option ‚send On @ boot of QS3+' is activated, this QS3+ will send automatically the „Power On"
command after powering the unit. If no active source is selected the unit will send „Power Off " after the
timer delay.
After entering all necessary parameters press ‚Selected Unit' to upload the command set to an individual
Quickselect 3.0+ that is connected to the display device via RS232. If identical display devices are
available for all participants that need to be controlled then the current command set can be uploaded
to all Quickselect units simultaneously by pressing ‚All Units'.
If several display devices coming from different manufacturers are used, an individual command set
can be entered and uploaded to the corresponding Quickselect for each display device via ‚Selected Unit'.
Repeat the process as described above for each consecutive display device.
Note: If the QS3+ units are connected in a daisy chain or ring setup, the command ‚send On @ boot of QS3+'
will not be transmitted via the following units. Normal Power Command will be transmitted via the complete
setup.

8. Operation by ShowMe button

If the Quickselect units are installed in a way so that they are directly accessible by the user (e.g. sitting
on a tabletop) then each unit can be activated by simply pressing the ShowMe button on the front or
automatically upon automatic signal detection (see section about enabling 'Auto Show' mode using the
GUI software).
In case of a hidden installation each Quickselect units provides a set of connectors for three external
switch-keys with status LED feedback, to allow the user to directly select a specific input when the
connectors are extended, e.g. into a table connection plate.
Install the QuickSelect under the table with the mounting brackets so that the label points up; wire the
connection field with the QuickSelect accordingly.
The rear ShowMe-connection acts like the integrated ShowMe-button. If only one source is connected,
the active input is automatically chosen when pushing the ShowMe button. Otherwise, the inputs are
switched through cyclically.
LED
GND
KEY
e. g. CablePort desk for QuickSelect 3.0
2
Ref. No. 7430 000 008
NC
+ -
NO
C
33