Kindermann QuickSelect 3.0+ Installations- Und Bedienungsanleitung Seite 23

The signal inputs at the device can either be activated directly via the ShowMe button or via external
buttons (connected to Phoenix terminals at the rear). If an active source is connected in automatic mode,
this input is directly activated by an automatic signal recognition.
Those outputs can be switched to different signal inputs (one locally and one HDBT-In).
Within the serial circuit, every device can output infed signals from previous transmitters in the chain
via the HDMI-output. Thus, several devices can output the same signal as receivers at the end of the chain
(split function). The HDMI output signal has the same resolution as the activated input. Analogue VGA
input signals can be scaled up to 1080p or WUXGA resolution. The audio input can be used for playback
of analogue audio only, even without an active VGA signal being connected to the VGA input ("Audio
only" function). This function allows playback of music and other sound files by using smartphones and
MP3 players.
A free configuration software can be used to configure, visualize and control all devices that are
connected via the bus using an intuitive, graphical interface. To use some of the functions you´ll need to
use this GUI.
The automatic address awarding of the devices connected to the bus can be triggered manually at the
device or via the software. Alternatively, it can be set manually with two BCD switches at the device.
Reading the EDID information from the display device (display or projector) connected to the last
Quickselect's HDMI- or HDBT output can be triggered manually at the device or via the software.
Alternatively, predefined tables can be filed at the Quickselect inputs. Thus, the EDID data will be
available at all device inputs and demand precisely these settings from the signal sources.
The RS232 port at the devices serves external control of the units, e.g. with the software or a media
control. The Display Power Control feature allows direct automatic power-on/off switching of one or
more displays or projectors upon signal detection, even without using an external AV control system.
For power on/off switching an individual timeout can be configured.
This control via RS232 can be used locally or with the embedded RS232 in the HDBT-Out (only with
compatible devices).
Functions
• Input selection either via contact inputs, ShowMe button, RS232 or by integrated automatic signal recognition.
• Conversion of input signals to HDBT for long distance transmission via Cat-6/7 (AWG23) across
long distances (picture and sound unidirectional, RS232 and LAN bidirectional).
• The range is up to 100 m at 1080p, 4K60 up to 30 m.
• Integrated EDID management.
• Supports HDMI 1.4 with 3D and 4K.
• Supports HDCP.
• Can be controlled via contact inputs, with feedback outputs for LED.
• RS232-connection to control the system: Compatible with PC control software and media controls
also of third-party manufacturers.
• Control function: RS232 can be used to send commands to the devices connected to the receiver.
• Stable, anti-static metal housing for good long-term protection (incl. mounting brackets and device feet).
• Scalable system (several devices can be combined in one installation) for up to 32 units in chain or ring
topology.
• Ring topology for simultaneous local preview for each participant.
• Display Power Control function for automatic power on/off switching of one or more display devices
upon signal detection. Power on/off switching with configurable timeout.
• Quick setup with Auto-EDID function for HDMI or HDBT signal transmission.
• Free installation option, e. g. on-table installation and undertable installation, interim ceiling.
• Distributed Ethernet HUB up to 100Mbit.
23