Stand-Alone Mode; Control Board - EuroLite LED IP T1000 WW Bedienungsanleitung

Stand-alone Mode

In the stand-alone mode, the LED IP T1000 WW can be used without DMX-controller. Disconnect the LED
IP T1000 WW from the DMX-controller.

Control Board

The Control Board offers several features: you can simply set the starting address or run the pre-
programmed program.
The main menu is accessed by pressing Menu until the display is lit. Browse through the menu by pressing
Up or Down. Press the Enter button in order to select the desired menu. You can change the selection by
pressing Up or Down. Confirm every selection by pressing the Enter button. You can leave every mode by
pressing the Menu button. The functions provided are described in the following sections.
Default settings shaded.
Main
Sub menu
menu
ADDR 001~ XXX
W
STAT
SHUT
CHMD
LIN, SQR, ISQR,
DIM
SET
DISY
LOCK
SOFT
Info
POW
LOAD YES/NO
Display
0-255
0-255
1CH
3CH
SCUR, LIN.,
SQR., ISQR.,
SCUR.
ON
2MIN
YES/NO
Vx.x
100%
DMX address setting
Dimmer intensity of LED color
(Master mode)
Please note: In order to save the color
value set via the UP/DOWN button,
press ENTER twice (until the display
shows xxx*).
Strobe effect with increasing speed
Setting DMX channel mode
LIN - Linear dimmer curve, response
characteristics of LED,
SQR - - Square dimmer curve,
response characteristics of LED,
ISQR - Inverse square dimmer curve,
response characteristics of LED,
SCUR - S-shaped dimmer curve,
response characteristics of LED,
LIN. - Linear dimmer curve, response
characteristics of halogen lamp,
SQR. Square dimmer curve, response
characteristics of halogen lamp,
ISQR. - Inverse square dimmer curve,
response characteristics of halogen
lamp,
SCUR. - S-shaped dimmer curve,
response characteristics of halogen
lamp
Display shutoff
ON – permanent on
2MIN - shut off the display after 2
minutes
Keylock
YES – Keylock after 2 minutes. To
unlock press any key for 10 seconds.
Software version
Service function
Restore factory settings
24/28
Function
00101995, Version 1.0