Setting Up; Check Contents Of Pack; Connecting The Receiver; Connecting The Telephone - AUDIOLINE Klassiktelefon 1892 Bedienungsanleitung

2.

Setting Up

2.1

Check contents of pack

The following items are supplied:
one telephone base
one telephone connecting cable

Connecting the receiver

2.2
After unpacking your telephone, you must first connect the telephone receiver to the telephone
base. Take the end of the spiral cable and plug it into the socket HANDSET of the telephone
base HANDSET.
2.3

Connecting the telephone

Connect the telephone cable supplied to the telephone socket and the telephone jack TEL
LINE of the telephone base. The telephone works using the MF system (Tone Dialling).
Important note!
Before using the telephone for the first time, please observe the following instructions:
1. Connect the telephone as described in the operating instructions.
2. Before the first call can be received, you must first lift the receiver and wait for the dialling tone.
3. Replace the receiver and your telephone is ready for use.
This procedure should also be repeated if the telephone has not been used for some time.
3.

Operation

3.1

Making a call

Your telephone can be used like any conventional telephone.
Please follow the instructions:
Lift the receiver and wait until you hear the dialling tone.
Now dial the required telephone number.
To end the call, replace the receiver on the rest.
3.2

Receiving calls

When a call comes through, you will hear the ringing tone. The call can now be accepted using the
receiver.
3.3

Redial facility

If a connection that you have dialled is engaged or you were unable to get through to anybody, simply
replace the receiver. The last number dialled remains stored in the telephone automatically. The redial key
is in the center of the dial area. To use the redial facility, lift the receiver and press the redial button. The
stored redial number will now be dialled.
8
- Operating Instructions -
one telephone receiver with cable
one instruction manual