IKEA FROSTKALL Handbuch Seite 23

ENGLISH
Problem
Water flows on the floor.
Temperature cannot be set.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The melting water outlet is
not connected to the evap-
orative tray above the
compressor.
The Shopping Function is
switched on.
The Fast Freezing function
is switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products temper-
ature is too high.
Many food products were
inserted at the same time.
The door has been
opened too often.
The Fast Freezing function
is switched on.
The Shopping Function is
switched on.
There is no cold air circula-
tion in the appliance.
Solution
Attach the melting water outlet
to the evaporative tray.
Switch off Shopping Function
manually, or wait until the
function resets automatically
to set the temperature. Refer
to " Shopping Function".
Switch off Fast Freezing func-
tion manually, or wait until the
function resets automatically
to set the temperature. Refer
to "Fast Freezing function".
Keep the Mode pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Insert less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "Fast Freezing func-
tion".
Refer to "Shopping Function".
Make sure that there is cold
air circulation in the appliance.
23