Prior To Fi Rst Use; Assembling The Appliance; Operation - Silvercrest SFR 3.7 A1 Bedienungsanleitung

Prior to fi rst use
GB

Assembling the appliance

1) Remove all packaging materials from the
appliance.
2) Push the vacuum attachment 1 onto the
connecting piece 2.
NOTE
► This appliance is supplied with non-charged
batteries. The batteries must be charged for
3.5 hours before the fi rst use.
3) Charge the appliance (see Chapter "Charging
the appliance").
The appliance is now ready for use.

Operation

ATTENTION! DAMAGE TO PROPERTY!
► Do not use foaming, corrosive, aggressive,
abrasive or chemical cleaning agents.
These can damage the appliance.
1) Set the tip of the spray nozzle q to STREAM
(fi ne water mist) or SPRAY (coarse water mist).
2) Attach the spray nozzle q to the wiping attach-
ment 0.
3) Place the positioning ring w over the tube and
put it onto the spray nozzle q so that it clicks
into place.
4) Fill the spray bottle with water and, if desired,
with a cleaning agent suitable for window
cleaning.
5) Screw the spray nozzle q with the fi tted
wiping attachment 0 onto the spray bottle.
6) Pull the microfi bre attachment z over the
retainer on the wiping attachment 0 and
secure it with the velcro fastener.
7) Spray the surface that you wish to clean.
6
8) Using the microfi bre attachment, z wipe over
the sprayed areas and loosen any stubborn
dirt.
9) Press the on/off switch 6. The indicator light 8
lights up red.
NOTE
If the indicator light 8 fl ashes red during
►
use, this indicates that the appliance needs
to be charged (see chapter on "Charging the
appliance").
10) Move the blade of the vacuum attachment 1
slowly from top to bottom across the wet
surfaces. The moisture is removed and sucked
into the dirt container 5.
NOTE
► Never drag the blade sideways across wet
surfaces. Doing so prevents the water from
being vacuumed up; instead, it runs off the
side of the blade.
11) After you have fi nished a section, always start
again at the top.
ATTENTION! DAMAGE TO PROPERTY!
► Only continue working until the MAX mark
on the dirt container 5 is reached. Then
switch off the appliance and empty the dirt
container 5.
Remove the plug on the dirt container 5.
Pour away the dirty water and reclose the dirt
container 5. You can then resume working.
12) Once the entire surface is dry, press the on/
off switch 6 again to switch the appliance off .
The indicator light 8 goes out.
13) If necessary, dry off any streaks or remaining
moisture on the surface with a dry cloth.
SFR 3.7 A1