Using Your Baby Monitor - Philips SCD464 Bedienungsanleitung

Getting your baby monitor ready
EN

Using your baby monitor

8
Battery operated use
1 Remove the battery compartment cover (B-11) of the parent
unit, by sliding down the cover
2 Insert three 1,5V AAA batteries, noting the + and –
configuration inside the battery compartment (batteries are
not supplied, we recommend Philips Alkaline batteries)
3 Slide the battery compartment cover (B-11) back in place
until it clicks in position
The parent unit is now ready for battery operated
use.
1 Position both units in the same room to test the connection.
Make sure the baby unit is at least 1 meter / 3 feet away from
the parent unit.
2 Press the ON/OFF button (A-1) to switch on the baby unit.
> The POWER light (A-6) lights up green.
3 Switch on the parent unit using the ON/OFF switch (B-9) and
adjust the volume to the level you prefer using the VOLUME
control (B-9).
> The POWER light (B-9) lights up green.
> When connection has been established between the units,
the LINK light (B-3) on the parent unit lights up green.