krick Anna Anleitung Seite 16

Open the lid of the oiler and fill a drop (pea
size).
Screw the cover back. Just as with the water,
do not crush the O-ring. In this ball oil a 3 mm
ball is placed on a 0.6 mm bore. This prevents
the oil from passing too fast. Do not lose the
ball.
3. Oil the bearings
In the storage oil behind the flywheel give
some oil. If you add some cotton wool in the
oil beaker before, the oil runs through more
slowly.
Also add some oil to the crankbolts as well as
to the piston rod.
© Krick Modelltechnik, Knittlingen
As a bearing oil, resin-free oil is best suited. If
this is not available at the moment, a salad oil
can be used for a short time. However not
permanent.
4. Cheering
Fill fuel paste to about 3 mm below the edge.
Alternatively, Esbit tablets can also be placed
in the dish.
Light the firing paste and place the burner
shell under the boiler. Caution, the flame is
almost invisible.
Seite 2