Herunterladen Inhalt Inhalt Diese Seite drucken

Classic Buttonhole; Starting To Sew - ELNA eXperience 520 Installationsanleitung

Inhaltsverzeichnis

Werbung

Elna 520 Sewing Machine Instruction Manual
q
z
x
e
c
t
v
y
www.janomeflyer.com

Classic Buttonhole

w
e
Machine Settings
q Pattern:
w Presser foot:
e Needle thread tension: 1–5

Starting to sew

z
q
w
x
NOTE:
If the button is extremely thick, make a test buttonhole
on an extra piece of the fabric.
If it is difficult to fit the button through the test
buttonhole, you can lengthen the buttonhole by
pulling the button holder e back a little. The length of
the buttonhole will be increased.
c
v
u
i
o
NOTE:
Make sure there is no gap i between the slider u
and stopper o, otherwise the left and right lengths
will be different.
54
#16
Automatic buttonhole foot R
Press the up/down needle key to raise the
needle.
Attach the automatic buttonhole foot R snapping
the pin w into the groove q of the foot holder.
Pull the button holder to the back, and place
the button in it. Push it together tightly to the
button.
Pull the buttonhole lever t down as far as it will
go.
Insert the corner of the fabric under the foot.
Press the up/down needle button twice.
Remove the fabric to the left to draw the needle
thread through the hole of the foot.
Place the garment under the foot, and lower the
needle at the starting point of the buttonhole
mark y.
Then lower the automatic buttonhole foot R.
520 Owners Manual/ User Guide

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis