Replacing The Fuse - Powerfix PDM 250 A2 Bedienungsanleitung

POWERFIX PDM 250 A2

Replacing the fuse

To replace the fuse, proceed as follows:
Switch off the multimeter and remove all test leads before opening the multimeter!
 Remove the holster [2].
 Remove the two screws on the back of the multimeter and remove the back panel.
 Replace faulty fuse F1 (F 250mA / 250V) or F2 (F 10A / 250V) with a new one of the
same type.
 Replace the back panel and screw it tight with the two screws.
 Re-insert the multimeter in the holster [2].
16 - English