Cleaning; Environmental And Disposal Information; Conformity Information - Powerfix PDM 250 A2 Bedienungsanleitung

Cleaning

Switch off the multimeter and remove all test leads before cleaning the multimeter!
Use a dry cloth for cleaning and never use any solvent or cleaner that would corrode the plastic
materials. Ensure that no liquid enters the housing. Use a slightly damp cloth for more stubborn
dirt.

Environmental and disposal information

When this symbol appears on a product, this indicates that the product is
subject to the European Directive 2012/19/EU. All old electrical and
electronic devices must be separated from normal household waste and
disposed of at designated state facilities. The correct disposal of old devices in
this manner will prevent environmental pollution and human health hazards.
For further information about proper disposal, contact your local authorities,
waste disposal office or the shop where you bought the device.
Remember to protect the environment. Used batteries should not be disposed of in domestic
waste. They must be taken to a collection point for old batteries. Please note that only discharged
batteries may be deposited in collection bins for portable batteries. Care must be taken to ensure
that batteries that are not fully discharged do not short circuit.
Dispose of the packaging in an environmentally compatible manner. Cardboard can be put out
for municipal paper collections or brought to public collection points for recycling. Films and
plastic used for packaging the device are collected by your local disposal services and disposed
of in an environmentally compatible manner.

Conformity information

This device meets the basic requirements and other relevant regulations of the
EMC Directive 2004/108/EC, the Low Voltage Directive 2006/95/EC as
well as the RoHS Directive 2011/65/EU. The Declaration of Conformity can
be found at the end of these instructions.
POWERFIX PDM 250 A2
English - 17