Installation; Startup - Guntermann & Drunck MultiPower-12 Installationsanleitung

Installation

Installation
NOTE: The MultiPower-12
The maximum power consumption permitted per device is 600 mA.
1. Use a power loop cable to connect one of the
compatible devices (12VDC/600mA) to one of
the twelve Power Out
2. Connect one of the supplied power cables to the
socket.
Main Power
Connect the power cable to a power outlet.
3. If necessary, connect one of the supplied power
cables to the
Red. Power
redundant power supply.
Connect the power cable to a power outlet of another power circuit.

Startup

1. Turn on the power switch of the internal
2. Turn on the power switch of the internal
NOTE:
After you turn on the central power supply, the outputs are turned on suc-
cessively.
3 · MultiPower-12
supplies up to twelve devices with 12 Volt.
sockets.
socket to establish a
Power Out 1
power pack.
Main Power
power pack.
Red. Power
Power Out 2 Power Out 3